Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

Drum Christmas Ornament

22 likes
170 opens
65 copies
0 comments
Steve Carmichael

Project by

Steve Carmichael
MONROE, GA

General Information

This drum ornament is made from poplar and red cedar with gold thread around it in an X pattern. I used the X-Carve to cut it out! Merry Christmas!

Like this project Open in Easel®
1

Video and Basic Steps

4 minutes

Watch my video to see the basics of how this Drum Ornament was made, then follow these simple steps:
1. Cut the top and bottom pieces for the rims from 1/4" lumber.
2. Cut three circles for the body of the drum from 3/4" lumber.
3. Glue the body pieces together and sand smooth.
4. Glue on the top and bottom rims.
5. Spray with finish of your choice. I like Satin Lacquer.
6. Use a needle to weave thread or string around the drum in an X pattern.
7. Tie a loop at the end to hang on the tree.
Merry Christmas and Happy Holidays!