Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

CNCClamps

30 likes
396 opens
182 copies
3 comments
Douglas Caputo

Project by

Douglas Caputo

General Information

3", 4.5", and 6" Clamps. The 3" is handy for clamping the left side. The 6" is handy for clamping diagonal. Holes are for a 5mm threaded insert. I used a piece of scrap 5″×10″ oak.

Like this project Open in Easel®
Martin Gutzmer
did you just sand the ends?
Martin Gutzmer
Douglas Caputo
Yes. I just used my bench sander on the ends to put a bevel on it.
Douglas Caputo
Henry Miller
Made some using old bamboo flooring. Turned out great. Thanks for the share.
Henry Miller