Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Acrylic LED sign

5 likes
36 opens
12 copies
2 comments
Jeff Holmes

Project by

Jeff Holmes

General Information

Here is a sign I made to put next to my X-Carve. I never thought that there would be so much interest in these little signs but just about everyone that has seen it wants one of their own.
These are made from 1/8”acrylic cut to 6”x4” and the base is two pieces of ¼” birch plywood.

Like this project Open in Easel®
Stuart G
what's the design for the base? can you make it public?
Stuart G
Jeff Holmes
The base is just two pieces of 1/4 inch birch plywood where the bottom piece has a track cut for the LEDs and the top has a slot cut for the acrylic. I then glue the two together.
Jeff Holmes